FEYNLAB® A50 SUPER HEAVY CUTTING COMPOUND

FEYNLAB® A50 SUPER HEAVY CUTTING COMPOUND

Product Description

FEYNLAB® A50 SUPER HEAVY CUTTING COMPOUND is the most sophisticated cutting compound for automotive paint systems.

FEYNLAB® A50 SUPER HEAVY CUTTING COMPOUND contains the most advanced ceramic aluminum-oxide technology. These abrasives are incredibly hard and microscopically sharp compared to the competition. This means more cut, more consistency, and less product used compared to the competition.

A50 compound was specifically developed to remove swirls and deeper defects from automotive clear coat with ease, leaving behind a superior finish.

PRODUCT BENEFITS

• Effortless removal of even the deepest surface imperfections, including 1000 grit sanding marks
• Perfect for heavily used or oxidized vessels prior to FEYNLAB® coatings
• Fast and consistent cut
• Cost saving: less product used per job when compared against the competition
• Easy to wipe off and use

APPROVED SURFACES FOR APPLICATION – DO NOT apply to unapproved surfaces

Approved Surfaces:

• Automotive Clear Coat
• Gel-Coat Surfaces
• Marine Painted Surfaces 

Included 

1 kg or 5 kg of FEYNLAB® A50 SUPER HEAVY CUTTING COMPOUND

Cautions

We encourage to always wear gloves, an approved face mask, and eye protection when using any compounds or polishes.

Prepping the Surface

• Place vehicle in a well lit, cool, & contamination free environment.
• Remove any excessive surface dirt and contaminants using FEYNLAB’s® PURE WASH or PURE RINSELESS.
• If necessary, clay the surface to remove any surface bonded contaminants.

Rotary Polisher Directions

• Shake the bottle vigorously before use.
• Prepare the wool pad by placing 4 dime size dots and spread around on the area to be corrected.
• In general, begin with a 2 x 2 foot section. Decrease working area if heavier correction is necessary.
• Using a speed of no more than 1600 RPM, make 2 – 4 slow passes over the given area.
• Wipe clear with a clean microfiber towel.
• Check your results from multiple angles to ensure you have left zero residue.
• Admire your work. Take lots of pictures. Brag about it to your friends and give the FEYNLAB® team a virtual high five.

Dual-Action (DA) Polisher Directions

• Shake the bottle vigorously before use.
• Prepare the microfiber cutting pad by placing 4 dime size dots and spread around on the area to be corrected.
• In general, begin with a 2 x 2 foot section. Decrease working area if heavier correction is necessary.
• Using a speed of 3400 – 4000 OPM, make 2 – 4 slow passes over the given area.
• Wipe clear with a clean microfiber towel.
• Check your results from multiple angles to ensure you have left zero residue.
• Admire your work. Take lots of pictures. Brag about it to your friends and give the FEYNLAB® team a virtual high five.